How To Clean Your Garage Door Properly

Garage Door Repair Zionsville

Clean Your Garage Door Properly

When was the last time you cleaned your garage doors? You might be surprised by the answer. If so, you should inspect your garage door immediately. It’s likely that your garage door is already very dirty. It’s not enough to let the elements (such as rain or wind) take care of it.

What can you do now that you have finally seen how filthy your garage door is? You have the opportunity to clean your garage door yourself. You just need some tips and tricks to make it easy. Contact your nearest Garage Door Repair Zionsville today.

Here are some tips to properly clean your garage door:

How to clean a steel garage door

If your garage door is made of pre-finished steel, the following steps are required.

Step 1

Make one cup of mild detergent. The solution should not contain more than 0.5 percent of phosphate and 5 gallons of water. The solution can be used to clean the garage door.

Step 2

Use a mixture of water and bleach to remove oil stains. To ensure that the bleach and detergent don’t mix, make sure the garage door is thoroughly rinsed. You can then rinse the door once the stain is gone.

Step 3

Include the top, sides and behind the weather stripping on the garage door.

Step 4:

You can remove dirt from the door with your hands, or use a simple tool.

Step 5

Use a non-abrasive sponge or cloth to clean your garage door.

Step 6

After you have rinsed the door, dry it with a piece of cloth.

How to clean a wooden garage door

These are the steps to properly clean a wooden garage door.

Step 1

Use mild detergent and water. Use a sponge to soak the solution in before wiping off any dirt or debris from the door’s surface.

Step 2

Use a light garden sprayer to rinse the garage door thoroughly. Let the garage door dry completely.

Step 3

If your garage door’s exterior is already damaged or thinned, you can clean it with a detergent solution. Once it is dry, apply an oil/alkyd primer to prime the affected areas. You can either complete priming it or apply a coat of finish.

Step 4

Apply a coat of sealant to complete the cleaning process, especially if there are no eroded areas on your wooden garage doors.

To clean your garage door properly, follow the steps below. This shouldn’t be difficult if you follow the correct steps and use the right tools.

Leave a Comment

Your email address will not be published. Required fields are marked *